REMARKS :
#
IMPORTANT: 3 types of intake camshafts are available:
1/ 10305xx: vanos with 1 oil hole in the front bearing, oil groove in the middle of the bearing
2/ 10325xx: vanos with 2 oil holes in the front bearing, oil groove at the end of the bearing
3/ 10335xx: for use without vanos (like exhaust camshaft)
Please indicate the type of intake camshaft you need when ordering and use the correct partnumber digits, corresponding with the correct type of camshaft. All camshafts are steel billet and gundrilled for weight reduction
#
- valve clearance is to be adjusted using mechanical lash caps
-
please make sure that the lash cap does not touch the valve locks !
#
FOR COMPETITION APPLICATIONS ONLY. Following details must be verified:
-
the camshafs must turn smooth in the cylinderhead, provide free travel by machining where needed
-
distance between valve seal and retainer at full lift must be 0.6mm at least
-
minimum valve spring travel of 1.0mm at full lift must be provided
-
distance between valve and piston 1.0mm (pref. 1.5mm). check 5-15° before TDC on exhaust, and after TDC on intake
#
ONLY for use in competition engines with independent engine management (throttle position sensor) or carburettors